![]() ![]() When combining interfaces using a bridge, a MAC address is set on it, which will be broadcast to all slave interfaces. The bridge in the hierarchy of Mikrotik interfaces is a higher, unifying entity. Using a bridge, heterogeneous ethernet-shaped interfaces are also interconnected - ethernet, wlan, vlan, eoip, vpls. Bridge (in the Russian terminology “bridge”) performs packet switching due to the processor resources of the device. For this, some of them have a separate switch chip, as well as the ability to combine interfaces using a software switch - bridge. In addition to routing, MikroTik devices can also perform switching. In this article I will tell you how to get around this limitation using the advanced MikroTik functionality.įirst, recall the RouterBoard materiel. In the standard configuration, the rule “1 interface = 1 MAC” is respected. Usually this question remains unanswered, or the questioner is answered “no way”. Infrequently, but with enviable frequency, the same question arose in the profile forums: “how to get two IP addresses with different MACs on the same MikroTik router interface?”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |